Rainbow Electronics W90P710CDG User Manual
Page 312
W90P710CD/W90P710CDG
- 312 -
BITS
DESCRIPTIONS
[15]
Reserved
-
[14]
Reserved
-
[13]
Reserved
-
[12] R_DMA_IRQ
When recording, when the DMA destination current address reach
the DMA destination end address or middle address, the
R_DMA_IRQ bit will be set to 1 automatically, and this bit could be
cleared to 0 by CPU. The bit is hardwired to ARM as interrupt request
signal with an inverter.
The R_DMA_IRQ bit is read/write (write 1 to clear)
[11] T_DMA_IRQ
Transmit DMA interrupt request bit. When DMA current address
reach the middle address (((ACTL_DESE – ACTL_DESB)-1)/2 +
ACTL_DESB) or reach the end address ACTL_DESB, the bit
T_DMA_IRQ will be set to 1, and this bit could be clear to 0 by write
“1” by CPU. And the bit is hardwired to ARM as interrupt request
signal with an inverter.
The T_DMA_IRQ bit is read/write (write 1 to clear).
[8] IIS_AC_PIN_SEL
IIS or AC-link pin selection
• If IIS_AC_PIN_SEL = 0, the pins select IIS
• If IIS_AC_PIN_SEL = 1, the pins select AC-link
The IIS_AC_PIN_SEL bis is read/write
[7] FIFO_TH
FIFO threshold control bit
• If FIFO_TH=0, the FIFO threshold is 8 level
• If FIFO_TH=1, the FIFO threshold is 4 level
The FIFO_TH bit is read/write
[6]
Reserved
31
30
29
28
27
26
25
24
23
22
21
20
19
18
17
16
15
14
13
12
11
10
9
8
Reserved Reserved
Reserved
R_DMA_IRQ T_DMA_IRQ
Reserved
IIS_AC_PIN_
SEL
7
6
5
4
3
2
1
0
FIFO_TH Reserved
Reserved BLOCK_EN[1:0]
Reserved