Atmega32(l) – Rainbow Electronics ATmega32L User Manual
Page 25
![background image](/manuals/281832/25/background.png)
25
ATmega32(L)
2503C–AVR–10/02
The CKSEL0 Fuse together with the SUT1..0 fuses select the start-up times as shown in
Table 5.
Notes:
1. These options should only be used when not operating close to the maximum fre-
quency of the device, and only if frequency stability at start-up is not important for the
application. These options are not suitable for crystals.
2. These options are intended for use with ceramic resonators and will ensure fre-
quency stability at start-up. They can also be used with crystals when not operating
close to the maximum frequency of the device, and if frequency stability at start-up is
not important for the application.
Table 5. Start-up Times for the Crystal Oscillator Clock Selection
CKSEL0
SUT1..0
Start-up Time from
Power-down and
Power-save
Additional Delay
from Reset
(V
CC
= 5.0V)
Recommended Usage
0
00
258 CK
(1)
4.1 ms
Ceramic resonator, fast
rising power
0
01
258 CK
(1)
65 ms
Ceramic resonator, slowly
rising power
0
10
1K CK
(2)
–
Ceramic resonator, BOD
enabled
0
11
1K CK
(2)
4.1 ms
Ceramic resonator, fast
rising power
1
00
1K CK
(2)
65 ms
Ceramic resonator, slowly
rising power
1
01
16K CK
–
Crystal Oscillator, BOD
enabled
1
10
16K CK
4.1 ms
Crystal Oscillator, fast
rising power
1
11
16K CK
65 ms
Crystal Oscillator, slowly
rising power