Power-on reset, Atmega32(l), Figure 17. mcu start-up, reset extended externally – Rainbow Electronics ATmega32L User Manual
Page 36
36
ATmega32(L)
2503C–AVR–10/02
Power-on Reset
A Power-on Reset (POR) pulse is generated by an On-chip detection circuit. The detec-
tion level is defined in Table 15. The POR is activated whenever V
CC
is below the
detection level. The POR circuit can be used to trigger the Start-up Reset, as well as to
detect a failure in supply voltage.
A Power-on Reset (POR) circuit ensures that the device is reset from Power-on. Reach-
ing the Power-on Reset threshold voltage invokes the delay counter, which determines
how long the device is kept in RESET after V
CC
rise. The RESET signal is activated
again, without any delay, when V
CC
decreases below the detection level.
Figure 16. MCU Start-up, RESET Tied to V
CC
.
Figure 17. MCU Start-up, RESET Extended Externally
V
RESET
TIME-OUT
INTERNAL
RESET
t
TOUT
V
POT
V
RST
CC
RESET
TIME-OUT
INTERNAL
RESET
t
TOUT
V
POT
V
RST
V
CC