Ocean Optics OOIBase32 User Manual
Page 108
A: Experiment Tutorials
f.
Select a multiplicative factor to apply to the data before plotting or storing. Then, select
an additive constant or offset to apply to the data. OOIBase32 applies the additive constant or
offset after applying the factor but before plotting or storing data.
The equation for the Factor and Offset functions is:
Results = (Factor * Data) + Offset
2. Configure a time acquisition process for the second single wavelength (if desired). Select the
Channel B page and repeat Steps 1-3 for Channel B.
To configure a time acquisition process for the third, fourth, fifth, and sixth single wavelengths,
select the Channel C, Channel D, Channel E, and Channel F pages, respectively, and set the
necessary parameters.
3. Configure a time acquisition process for a combination of two time channels (if desired) by
selecting Combination 1.
Perform the steps below to configure a combination:
a.
Select Enabled to set the time acquisition calculation for the wavelength.
b.
Enable Plotted to see a real-time graph of the acquired data in a spectral window.
c.
Specify Time Channel A through F for the First Channel.
d.
Select the mathematical operation to produce the data for Combination 1.
e.
Specify Time Channel A through F for the Second Channel.
f.
Select a multiplicative factor to apply to the data before plotting or storing. Then, select
an additive constant or offset to apply to the data. OOIBase32 applies the additive
constant or offset after applying the factor but before plotting or storing data.
The equation for the Factor and Offset functions is:
Results = (Factor * Data) + Offset
4. Configure a time acquisition process for the Combination 2 page, if desired. This page is virtually
identical to the Combination 1 page, with the exception that you can choose Combination 1 for
the first or second channel in Combination 2.
5. Click
the
Apply button to apply the changes, and then click the OK button to close the Time
Acquisition Channel Configuration screen.
Proceed to the
Configuring the Time Acquisition Configuration Screen
Configuring the Time Acquisition Configuration Screen
1. Select
Time Acquisition | Configure | Configure Acquisition from the menu bar to open the
Time Acquisition Configuration screen.
2. Enable
Stream Data to Disk to save time acquisition data.
98
000-20000-020-02-0505