Ocean Optics OOIBase32 - Manual (Page 13)

Chapter 2
Configuring OOIBase32
Overview
The following sections will guide you in configuring your OOIBase32 software and your Ocean Optics
hardware components.
Note
If you are using a USB-based spectrometer, do NOT connect the spectrometer to the PC
until you install the OOIBase32 software. Follow the instructions contained in this
section to properly connect and configure your system.
Connecting an A/D Converter to the PC
If your hardware configuration requires you to connect an external A/D Converter to the PC, consult the
operating instructions for your particular model of A/D Converter for instructions on properly configuring
the equipment for use with OOIBase32. Currently supported A/D Converter models include:
• ADC1000-USB
• ADC1000-ISA
• ADC2000-PCI
Ocean Optics has discontinued the A/D Converters on the list below. The OOIBase32 software still
supports the use of these products:
• ADC500
• DAQ-700
• SAD500
To use one of these models, consult version 1.0 of the OOIBase32 Spectrometer Operating Software
Manual for specific instructions on connecting these models, or consult the operating instructions for the
A/D Converters directly.
000-20000-020-02-0505 3