Ocean Optics OOIBase32 - Manual (Page 118)

B: Toolbars
USB-LS-450
This toolbar contains shortcuts to options available from the Spectrum | Configure Data Acquisition
menu in OOIBase32, as well as options specific to the USB-LS-450 light source.
The table below details the options available in the USB-LS-450 toolbar:
Option Description
LED On Turns the LED in a USB-LS-450 on or off.
Modulate LED Enables or disables the modulation of the LED in a USB-LS-450.
Get Temp.
Enables or disables the temperature readings with each spectral
acquisition.
C/F Determines the units of temperature returned by the USB-LS-450.
NIR512
This toolbar contains OOIBase32 options specialized for use with the NIR Spectrometer.
The table below details the options available in the NIR512 toolbar:
Option Description
TEC On Turns the thermo-electric cooler in the NIR Spectrometer on or off.
Det. Temp. Set Point
Specifies the target temperature of the detector (in degrees Celsius) in
the NIR Spectrometer.
You must enable your selection with the Set button (below)
Set
Sets the value you entered in the Det. Temp. Set Point box into memory.
The cooler in the NIR will operate until the detector reaches this
temperature.
Current Det. Temp.
Displays the current temperature of the detector (in degrees Celsius) in
the NIR Spectrometer.
108 000-20000-020-02-0505