Ocean Optics OOIBase32 - Manual (Page 20)

2: Configuring OOIBase32
► Procedure
1. Select your spectrometer type from the Spectrometer Type drop-down menu.
2. Select the appropriate A/D converter for your spectrometer from the A/D Converter Type drop-
down menu.
Note
When using a non-USB A/D converter, you will need to set additional parameters on this
screen to properly configure your A/D converter. Consult the documentation for your
A/D converter hardware for specific instructions.
3. Configure the appropriate information based on your spectrometer and A/D converter type
(options that appear after you make the A/D Converter Type selection) and click the OK button.
OOIBase32 stores your configuration information, and the OOIBase32 software will run. You
will not need to re-enter this information the next time you start OOIBase32.
Spectrometer Configuration
You now need to configure your sampling system in OOIBase32. Perform the steps below to configure
OOIBase32 and your sampling system.
10 000-20000-020-02-0505