Ocean Optics OOIBase32 User Manual
Page 21
2: Configuring OOIBase32
►
Procedure
1. Select
Spectrometer | Configure from the OOIBase32 menu. The Spectrometer
Configuration screen appears.
2. The
Wavelength Calibration tab is selected. OOIBase32 should automatically load the
coefficients for each spectrometer channel in your system from the .SPEC file you specified.
If OOIBase32 did not load these values, manually enter the calibration values provided on the
Wavelength Calibration Data Sheet that came with your spectrometer.
3. Highlight each installed channel by clicking the appropriate radio button, and then check the
Enabled box for each installed spectrometer channel.
4. Select
the
A/D Interface tab and ensure that the values entered on this tab match the values
you entered in the Configure Hardware screen described in the previous section. Modify if
necessary.
000-20000-020-02-0505
11