Universal Audio Realtime Rack - Manual (Page 115)

Realtime Rack Manual Chapter 4: Realtime Rack Application 115
Device Buttons
Buttons displayed in this area depend on the number of Real-
time Rack units that are connected. The screenshot shows a
two unit system.
Identify Unit Buttons
The Identify Unit buttons (shown as “MADI 1-16” and MADI 17-32”
in the screenshot at right) display which MADI channels are being
processed by the Realtime rack unit(s).
When the hardware is properly connected, clicking the Identify
button(s) will flash the front panel LEDs on the unit processing those
MADI channels. This function is convenient when cabling and/or
troubleshooting.
Unit Buttons
These buttons perform several functions. They can be used
to rename the unit and add/remove units for offline configu-
rations. In a multi-unit configuration, they can re-order the
MADI channels processed by each unit without physically
rerouting the MADI cables.
Note: Italics in a Unit Button indicates the unit is offline.
• To rename the unit, double-click the button to enter a
different unit name. The default unit name is [Realtime Rack].
• To add a unit for offline configuration, click the “+” button.
• To delete an offline unit, click+hold a button and swipe (drag) to the right then
click the red remove icon.
• To re-order the MADI channels processed by each unit, drag and drop these but-
tons up and down as needed. Note this operation will cause a system reconfigura-
tion and there may be a delay before the operation is completed.
Display Tab
Each setting in the Display tab is described below.
Bank Size Menu
Sets the number of channels displayed in the
Channels Bar and the blue Bank Bar. To change
the bank size, click the BANK SIZE drop menu
and choose a new value from the menu.