Asus RS161-E4/PA2 - Manual (Page 109)

ASUS RS161-E4/PA2 6-3
6.2 NVIDIA ® RAID configurations
The motherboard includes a high performance SATA RAID controller integrated
in the NVIDIA ® nForce Professional 2200 chip. The RAID controller supports
RAID 0 and RAID 1 using the four independent Serial ATA channels.
6.2.1 Setting the BIOS RAID items
After installing the hard disk drives, make sure to set the necessary RAID
items in the BIOS before setting your RAID configuration.
To set the BIOS RAID items:
1. Enter the BIOS Setup during POST.
2. Go to the Main Menu, select IDE Configuration, then press <Enter>.
3. Set the RAID Option ROM item to [Enabled], then press <Enter>. The
master and slave drive list appears.
4. Enable the drives you want to set as RAID.
5. Save your changes, then exit the BIOS Setup.
• Refer to Chapter 5 for details on entering and navigating through the
BIOS Setup.
• The RAID BIOS setup screens shown in this section are for reference
only, and may not exactly match the items on your screen.