Asus RS161-E4/PA2 - Manual (Page 53)

ASUS RS161-E4/PA2 4-7
7. VGA Graphics controller setting (3-pin VGA_EN1)
These jumpers allow you to enable or disable the onboard ATI Rage XL
video graphics controller. Set to pins 1-2 to enable the video graphics
controller.
6. BIOS Recovery (3-pin RECOVERY1)
This jumper allows you to recover your original BIOS from a floppy disk in
case the BIOS codes and data are corrupted.
To recover the BIOS:
1. Turn OFF your computer and unplug the power cord.
2. Move the jumper cap from pins 1-2 (default) to pins 2-3.
3. Insert a floppy disk with the original or updated BIOS file.
4. Plug the power cord and turn ON the computer.
5. The system searches for the BIOS file in the floppy then reflashes
the BIOS.
6. When finished, shut down your computer.
7. Replace the jumper cap from pins 2-3 to pins 1-2.
8. Reboot your computer.
9. Hold down the <Del> key during the boot process and enter BIOS
setup to re-enter data.
R
KFN4-DRE
KFN4-DRE BIOS Recovery Setting
RECOVERY1
(Default)
Normal BIOS Recovery
1 2 2 3
R
KFN4-DRE
KFN4-DRE VGA_EN1 Setting
VGA_EN1
Enabled Disabled
(Default)
1
2
2
3