Asus RS161-E4/PA2 - Manual (Page 31)

2-15 ASUS RS161-E4/PA2
5. Install a PCI Express x16 card
to the bracket, then secure the
card with the screw you removed
earlier.
2.6.2 Reinstalling the riser card bracket
To reinstall the riser card bracket:
1. Take note of the holes on the riser card bay. The three pegs on the riser
card should match these holes to ensure that the bracket is properly in
place.
2. Install the riser card bracket with
the card into the PCI Express x16
slot on the motherboard.
3. Press the riser card bracket until
the golden connectors completely
fit the slot and the bracket aligns
with the rear panel.
4. Connect the cable(s) to the card, if
applicable.