Asus RS161-E4/PA2 - Manual (Page 28)

Chapter 2: Hardware setup 2-12
2.5 Hard disk drives
The system supports two hot-swap Serial ATAII hard disk drives.
To install a hot-swap SATAII HDD:
1. Release a drive tray by pushing
the spring lock to the right, then
pulling the tray lever outward.
The drive tray ejects slightly after
you pull out the lever.
2. Firmly hold the tray lever and pull
the drive tray out of the bay.
3. Take note of the drive tray holes.
Each side has three holes to fit
different types of hard disk drives.
Use two screws on each side to
secure the hard disk drive.
4. Place a SATAII hard disk drive on
the tray, then secure it with four
screws.