Asus SL1200 - Manual (Page 100)

83
Chapter 9 - Configuring Firewall/NAT Settings
ASUS SL1200
2. Click on the icon of the Self Access rule to be modified in the Self
Access rule table or select the Self Access rule from the Self Access
rule drop-down list.
3. You may then disable or enable the traffic from LAN or WAN or
both. The port number cannot be changed if TCP or UCP protocol is
selected. To modify the port number, you must first delete the existing
Self Access rule and add a new rule instead.
4. Click on < Modify> to save the changes. The new settings for this Self
Access rule will then be displayed in the Self Access rule table located
at the bottom half of the Self Access Rule Configuration page.
9.6.1.5 Delete a Self Access Rule
To delete a Self Access rule
1. Open the Self Access Rule Configuration page. See section 9.6.1.2
Access Self Access Rule Configuration Page.
2. Click on the icon of the Self Access rule to be deleted in the Self
Access rule table or select the Self Access rule from the Self Access
rule drop-down list.
3. Click on < Delete> to delete the rule. The rule deleted will be removed
from the Self Access rule table located at the bottom half of the same
configuration page.
9.6.1.6 View Configured Self Access Rules
To see existing Self Access Rules, just open the Self Access Rule
Configuration page as described in section 9.6.1.2 Access Self Access
Rule Configuration Page
9.6.2 Configuring Service List
Services are a combination of Protocol and Port number. It is used in
inbound and outbound ACL rule configuration. You may use Service
Configuration Page to:
• Add a service, and set parameters for it
• Modify an existing service