Asus SL1200 - Manual (Page 92)

75
Chapter 9 - Configuring Firewall/NAT Settings
ASUS SL1200
9.4.2 Access Outbound ACL Rule Configuration Page –
(Firewall -> Outbound ACL)
Log into Configuration Manager as administrator. Click Firewall ->
Outbound ACL. The Firewall Outbound ACL Configuration page displays
as shown in Figure 9.9.
When you open the Outbound ACL Configuration page, a list of existing
ACL rules is also displayed at the bottom half of the configuration page
such as those shown in Figure 9.9.
9.4.3 Add Outbound ACL Rules
To add an outbound ACL rule
1. Open the Outbound ACL Rule Configuration Page. See section 9.4.2
Access Outbound ACL Rule Configuration Page.
2. Select Add New from the ID drop-down list.
3. Set desired action (Allow or Deny) from the Action drop-down list.
4. Make changes to any or all of the following fields: source/destination IP,
source/destination port, protocol, NAT, time ranges, application filtering,
log, and VPN. Please see Table 9.2 for explanation of these fields.
5. Assign a priority for this rule by selecting a number from the Move
to drop-down list. The number indicates the priority of the rule with 1
being the highest. Higher priority rules will be examined prior to the
lower priority rules by the firewall.
6. Click on the < Add> button to create the new ACL rule. The new ACL
rule will then be displayed in the outbound access control list table at
the bottom half of the Outbound ACL Configuration page.
Figure 9.10 shows how to create a rule to allow outbound HTTP traffic.
This rule allows outbound HTTP traffic to be directed to any host on the
external network for a host in your LAN w/ IP address 192.168.1.15.