Asus SL1200 - Manual (Page 68)

51
Chapter 7 - Configuring Routes
ASUS SL1200
Table 7.2. Static Route Configuration Parameters
Field Description
Destination IP Address Specifies the IP address of the destination computer or
an entire destination network. It can also be specified
as all zeros to indicate that this route should be used
for all destinations for which no other route is defined
(this is the route that creates the default gateway). Note
that destination IP must be a network ID. The default
route uses a destination IP of 0.0.0.0. Refer to 13.1
IP Addresses for more details on IP addresses.
Destination Netmask Indicates which parts of the destination address refer to the
network and which parts refer to a computer on the network.
The default route uses a netmask of 0.0.0.0. Refer to 13.3
Subnet masks for more details on network masks.
Gateway IP Address Gateway IP address
5. To enable or disable RIP passive mode, click the Enable or Disable
radio button.
6. Select RIP version for sending and receiving routing information from
the respective drop-down list.
7. To enable or disable authentication, click the Enable or Disable radio
button. You must also select the RIP authentication mode and enter
authentication key if authentication is enabled.
8. Repeat steps 1 to 5 if you want to configure another interface to support
routing information exchange.
9. Click < Apply> to save the RIP configuration.
7.3 Static Routing
7.3.1 Static Route Configuration Parameters
Table 7.2 defines the available configuration parameters for static routing
configuration.