Operating instructions – Armasight TAT163WN7ZEUS31 Zeus 640 3-24x75 (30Hz) Thermal Imaging Rifle Scope User Manual
Page 18
18
3
OPERATING INSTRUCTIONS
3.1 INSTALLATION AND MOUNTING
3.1.1 BATTERY INSTALLATION
CAUTION:
Verify that the equipment is off before installing a battery.
Install two CR123A batteries as follows (refer to Figure 3-1):
1. Unscrew the battery cap (not shown) by hand.
2. Open the hinged contact clamping plate (C).
3. Install the batteries (D) into the battery compartment. Align the polarity symbols on the batteries
with the polarity symbols (A and B) on the body of the Zeus.
4. Replace the contact clamping plate (C).
5. Replace the battery cap.
3.1.2 INSTALLING THE ZEUS ON A PICATINNY/WEAVER RAIL
WARNING:
When installing the equipment on a weapon, verify that the weapon is clear and that the safety
is on before proceeding.
A
b
C
D
FIGURE 3-1. BATTERY INSTALLATION