6 installing additional equipment on the zeus, 8 connecting an external power source to the zeus – Armasight TAT163WN7ZEUS31 Zeus 640 3-24x75 (30Hz) Thermal Imaging Rifle Scope User Manual
Page 21
21
3.1.5 FASTENING AN ADVANCED WIRELESS REMOTE CONTROL TO A
WEAPON
Using Velcro tape (A, Figure 3-7), fasten the remote control (B) to your weapon in an easily accessible
place (e.g., on the front of the rifle stock).
If your rifle has a Picatinny or Weaver rail on the front end, you can use the Picatinny adaptor for the
Advanced Wireless Remote (C). Install the adaptor onto the rail (D). Insert the remote control unit into
the adapter.
FIGURE 3-7. ADVANCED WIRELESS REMOTE CONTROL
A
b
b
C
D
3.1.6 INSTALLING ADDITIONAL EqUIPMENT ON THE ZEUS
Use a Platform Ring (optional) to install any additional equipment, such as the Armasight MCS Minia-
ture Collimating Sight. For adapter mounting procedures, see Part 3.1.4.
Use the side Picatinny/Weaver rail to install any additional equipment, such as the Armasight DT Digital
Video Recorder, a rangefinder, or an external power source.
3.1.7 CONNECTING AN EXTERNAL VIDEO RECORDER/DISPLAY
TO THE ZEUS
Use a video cable (optional) to connect an external video recorder/monitor/TV to the input/output
connector (15, Figure 2-2).
CAUTION:
Turn off the Zeus before you begin connecting/disconnecting any external equipment.
After removing the cable, replace the protective cap over the connector.
3.1.8 CONNECTING AN EXTERNAL POWER SOURCE TO THE ZEUS
Use a video cable (optional) to connect an external 6 VDC/1a power source to the input/output con-
nector (15, Figure 2-2).
CAUTION:
Remove the batteries before you connect any external power source.
To avoid a sudden loss of power, turn off the Zeus before removing the batteries or disconnect-
ing the external power source.
CAUTION:
After removing the cable, replace the protective cap over the connector.