Armasight TAT163WN7ZEUS31 Zeus 640 3-24x75 (30Hz) Thermal Imaging Rifle Scope - Manual (Page 19)

19
NOTE:
Zero the weapon prior to installing and bore sighting the Zeus.
The Zeus comes fully-assembled with a Picatinny/Weaver mount (Figure 3-2).
The mount (C) coupled with the raiser (D) is attached to the Zeus seating rail (E) with two M4×20 flat-
head socket cap screws (A).
Install the Zeus on a Picatinny/Weaver rail as follows:
1. To unlock the mount’s clamping device (A): push down on the dog (B, see Figure 3-3) and unlock the
cam lever (C).
2. Install the Zeus on the Picatinny/ Weaver rail so that the recoil stop (B, see Figure 3-2) slides into one
of the rail’s transverse slots.
3. Secure the Zeus to the rail by locking the cam lever (A, see Figure 3-3).
4. Verify that the clamping device is securely holding the Zeus. If necessary, adjust the clamping device
as detailed in Part 3.1.3 (Clamping Device Adjustment).
FIGURE 3-3. MOUNT. TOP VIEW
C
b
LOCKED POSITION UNLOCK POSITION
A
3.1.3 CLAMPING DEVICE ADjUSTMENT
1. Unlock the clamping device and remove the Zeus from the weapon.
2. To tighten/loosen the clamping device (B, see Figure 3-4), push the cam (C, see Figure 3-4) towards
the arrow (which will cause the nut (A, see Figure 3-4) to slide out of its hole). Turn the nut (A) CW/
CCW respectively in one-two increments (see note below). Much like when the cam (C) is released,
the backward-moving springs will cause the nut (A) to slide back into its hole.
A
b
C
D
E
FIGURE 3-2. THE ZEUS FULLY ASSEMBLED WITH THE MOUNT