Armasight TAT163WN7ZEUS31 Zeus 640 3-24x75 (30Hz) Thermal Imaging Rifle Scope - Manual (Page 32)

32
10. Fire a series of shots to check the boresight.
11. After completing the boresight adjustment procedure, turn off the Zeus and place the cap over the
objective lens.
TABLE 3-3. CALCULATING BORESIGHT CORRECTIONS (100M FIRE RANGE)
ZEUS VERSION
ZE
U
S 4 160
-30
ZE
U
S 7 160
-30
ZE
U
S 3 336
-30
ZE
U
S 3 336
-60
ZE
U
S 2 640
-30
ZE
U
S 2 640
-60
ZE
U
S 5 336
-30
ZE
U
S 5 336
-60
ZE
U
S 3 640
-30
ZE
U
S 3 640
-60
Angular Boresight Increment 2 MOA 1.1 MOA 1.3 MOA 0.76 MOA
Boresight Increment in metric units* 6 3.3 3.9 2.3
Measured Windage/Elevation
Deflection of the Centre of Impact
from the Target Centre
12cm/ 23cm,
for example
10cm/ 7cm,
for example
12cm/ 16cm,
for example
5 cm/ 23 cm,
for example
Correction
Value Windage 12/6=2
reticle shifts
10/3.3≈3
reticle shifts
12/3.9≈3
reticle shifts
5/2.3≈2
reticle shifts
Elevation 23/6≈4
reticle shifts
7/3.3≈2
reticle shifts
16/3.9≈4
reticle shifts
23/2.3≈10
reticle shifts
* To calculate boresight increment value in metric units for a fire range R different from 100m, use the
coefficient R/100. So at a range R (in meters) the boresight increment is:
6×R/100, cm — for Zeus 4 160-30;
3.3×R/100, cm — for Zeus 7 160-30;
3.9×R/100, cm — for Zeus 3 336-30/ Zeus 3 336-60/ Zeus 2 640-30/ Zeus 2 640-60;
2.3×R/100, cm — for Zeus 5 336-30/ Zeus 5 336-60/ Zeus 3 640-30/ Zeus 3 640-60.
3.3.3 ZEUS SHUT-DOWN
NOTE:
Shut down the Zeus properly to avoid losing unsaved settings and data.
Shut-down the Zeus as follows:
1. Be sure to save your settings and data.
2. Turn off the Zeus.
3. Replace the cap on the objective lens.
4. Disconnect the cable (if applicable).
5. Place the cap on the connector.
6. Dismount the Zeus from the weapon.
7. Remove the batteries.
CAUTION:
Do not store the Zeus with the batteries still in it.
8. Store the Zeus and all accessories in the carrying case.