Armasight TAT163WN7ZEUS31 Zeus 640 3-24x75 (30Hz) Thermal Imaging Rifle Scope - Manual (Page 20)

20
NOTE:
The eight-sided nut of the clamping device will only fit into its hole if turned in one of the dis-
crete positions using increments equal to 360°/8.
3. Verify that the adjusted clamping device is securely holding the Zeus.
FIGURE 3-4. MOUNT. UNDERSIDE VIEW
LOCKED POSITION UNLOCK POSITION
A
b
C
3.1.4 MOUNTING A PLATFORM RING TO THE ZEUS
Figure 3-5 shows the Zeus with the Platform Ring adapter (A, Figure 3-5) installed.
Mount the Platform Ring (optional) on the Zeus as follows (refer to Figure 3-6):
1. Using a 1.5 hex key, unscrew the both clamp screws (C).
2. Place the clamps (B, D) onto the mounting tube (as in Figure 3-5). Screw the clamps together without
tightening the screws (C).
3. Adjust position of the Platform Ring until its rail (A) is level. Apply a small amount of thread lock to
the threads and tighten the screws (C).
A
A
FIGURE 3-5. THE ZEUS FULLY ASSEMBLED WITH THE PLATFORM RING
A
b
C
C
D
FIGURE 3-6. PLATFORM RING