Xylem IM250R03 Aquavar CPC-FD - Manual (Page 6)

6
Installation Flow Chart
The installation of Input Disconnect configurations for Aquavar CPC drives follows the outline
below. The steps must be carried out in the order shown. At the right of each step are refer-
ences to the detailed information needed for the correct installation of the unit.
NOTE! References in the middle column below are to the Aquavar CPC User’s Manual
(IM167). References in the third column below are to this manual.
Refer to the
Additional Reference
Task Aquavar CPC User’s Manual
in this Manual
“Installation” Section
PREPARE for “Preparing for Installation” • R7/R8: “Lifting the Drive”
installation on page 7.
• “Drive Identification” on page 8.
• “Suitable Mounting Location”
on page 9.
PREPARE the “Prepare the Mounting Location” • R7/R8: “Prepare the Mounting
Mounting Location – R7 and R8” on
Location page 9.
• “Dimensions and Weights
(Supplement to Aquavar CPC
User’s Manual)” on page 27.
REMOVE the “Remove Front Cover” R7/R8: “Remove Side Panel- R7 and
front cover R8 NEMA 1 and 12 Enclosures” on
page 9.
MOUNT the drive “Mount the Drive” R7/R8: “Mount the Drive” on
page 10.
INSTALL wiring “Wiring Overview” and “Installing the Wiring (Supplement
“Install the Wiring” to Aquavar CPC User’s Manual)”
starting on page 10.
CHECK installation “Check Installation” —
REINSTALL the “Reinstall Cover” —
cover
APPLY power “Apply Power” —
START-UP “Start-Up” —
INSTALLATION