Xylem IM250R03 Aquavar CPC-FD - Manual (Page 8)

8
Preparing for Installation (Supplement to Aquavar CPC User’s Manual)
Drive Identification
To identify the type of device you are installing, refer to the type code number on the device
identification label.
• Wall mounting base drives – label attached on the side surface of the heat sink.
• Packaged drive with screw cover – label attached to outside surface on the left ide of the
enclosure.
• Enclosure with hinged cover/door – label on inside surface of the cover/door.
Type Code Number
Use the following to interpret the type code found on the identification label.
CPC 4 370 1 FD
AQUAVAR ® (Series)
Voltage
2 – 208-240 Volt
4 – 480 Volt
5 – 575 Volt
Amps
370 Amps
*See Technical Section
NEMA Enclosure Rating
1 – NEMA 1
2 – NEMA 12
Disconnect with Drive Fuses
NOTE: Standard equipment on 200 HP and above models, R7-R8 Frames.
Options
* Consult factory for other options, if available. Not all combinations may be available.
Ratings and Frame Size
Charts in the “Ratings” sections of the Aquavar CPC User’s Manual and this manual list
technical specifications, and identify the drive’s frame size.
NOTE! Some instructions in this document vary, depending on the drive’s frame size. To
read the Ratings table, you need the “Output current rating” entry from the type code (see
above).
INSTALLATION