Xylem Lab 960 - Manual (Page 41)

Lab 960 Operation
41 ba75557e05 11/2009
Note
If there are not enough memory locations available for your
measurements:
z Output and backup the data storage (see page 42) and
z clear the memory (see page 43).
Switching off the
automatic storing
function
You can terminate the automatic storing function in the following ways:
z set the storage interval (Int.1) to OFF, or
z switch the meter off and then on again.
4 Confirm with <OK>.
Ident and the ID number that was last set is displayed.
5 Set the required ID number with <
▲><▼>.
6 Confirm with <OK>.
The meter switches to the measured value display and starts
the measuring and storing procedure.
AutoStore flashes on the display.
7 As soon as all of the 800 memory locations are occupied,
AutoStore is terminated (Int.1 = OFF).