Alpha Technologies INEX Inverter System - Manual (Page 15)

Argus Technologies Ltd. 014-114-C0 Rev D WC
Printed in Canada. © 2008 Argus Technologies Ltd. ARGUS and INEX are registered trademarks of Argus Technologies Ltd. All Rights Reserved. Page 5 of 43
2. The shelf should be mounted to the rack using at least two
#12 – 24 x 1/2” screws in each bracket. Philips-type screws
and screwdriver should be used to eliminate the possibility of
slippage and scratching of the unit’s exterior. Washers (such
as internal tooth) or special screws that are designed to cut
through the painted surface should be used to ensure a good
chassis ground.
3. Put the inverter shelf into the equipment rack horizontally,
and align holes of mounting brackets and rack.
4. Each inverter shelf holds maximum two inverter modules.
Repeat the steps above to install the inverter shelves as
required.
5. All input and output connections are made through the knockouts, located in the top
and the bottom of the shelf rear cover, as well as both side panels.
Remove the rear cover to access the inverter shelf backplane and connectors.
6. Knockouts on top and bottom are for shelf inter-connections and supplementary wire
routing. To remove knockout, snip tabs, move plate up and down until tabs in back
snap apart.