Alpha Technologies INEX Inverter System - Manual (Page 32)

Argus Technologies Ltd. 014-114-C0 Rev D WC
Printed in Canada. © 2008 Argus Technologies Ltd. ARGUS and INEX are registered trademarks of Argus Technologies Ltd. All Rights Reserved. Page 22 of 43
5.3 Interface Module Implementation
NOTE: IFC is pre-installed on the 030-420-10 shelf.
1. To install interface module, the rear cover must be removed.
2. Plug one end of the supplied flat cable to CN1 connector, and route the other end through the hole on the
controller/interface/STS shelf backplane as shown.
3. Cover up the controller/interface shelf backplane with the rear cover.
4. Pull the other end of flat cable to the front of INEX inverter system, and plug the cable to the cable socket on
the interface module PCB shown below: