Alpha Technologies INEX Inverter System - Manual (Page 30)

Argus Technologies Ltd. 014-114-C0 Rev D WC
Printed in Canada. © 2008 Argus Technologies Ltd. ARGUS and INEX are registered trademarks of Argus Technologies Ltd. All Rights Reserved. Page 20 of 43
5 Module Installation and Removal
5.1 Installation and Removal of STS and Inverter Modules
1. Install the inverter or STS module by sliding it into a pre-wired rack mount shelf until the faceplate is flush with
the mounting ears.
2. In order to prevent the inverter or STS module removal, turn the lock bolt counter-clockwise to LOCK position.
CAUTION
Parallel connection of inverter modules with different specifications would lead to serious
damage, and is not covered by the warranty. Use supplied nylon guide pins for securing only
inverter modules of the same specifications.
Inverter shelf holds only inverter modules; STS module will not fit in an inverter shelf.
3. Each inverter shelf holds maximum two inverter modules. Repeat previous steps to insert inverter module to
inverter shelf as required.
4. Inverter or STS module can be removed by pulling on the handle after turning the lock bolt to the UNLOCK
position. CAUTION: STS is not hot swap without MBS.
5. You can cover the excess cavity with an optional blank plate as follows:
The optional cover plate comes into two pieces: orthogonal silver metal piece and black coated cover plate.
6. After screwing the inner silver metal piece to the shelf bottom plate, use bolts on both sides to attach the
black metal cover to the inner silver piece.