B&K Precision 4045B - Manual - Manual (Page 81)

81
4.8.3 Device Trigger Commands
a) *TRG - Trigger command
This command is analogous to the IEEE 488.1 Group
Execute Trigger interface message, and has the same
effect. It is used to trigger the device to output a wave, and
is accepted only when the trigger mode is set to Trigger,
Gate or Burst, and the trigger source is set to BUS.
Type: Common Command
Syntax: *TRG
4.8.4 Stored Settings Commands
*RCL - Recall instrument state
This command is used to restore the state of the device to
that stored in the specified memory location.
Arguments
Type <NRf>
Range 0 to 19 (4045B). Non integer values are
rounded before execution
Type: Common Command
Syntax: *RCL<ws><NRf>
Example: *RCL 0 (Recall default state)
*RCL 9