Q.V.P. VAK-MATIC: VM2FS, VM4FS, & VM6FS Set up User Manual

Quality vakuum products, inc

Advertising
background image

Quality VAKuum Products, Inc.

Or visit our site at

www.qualityvak.com

74 Apsley St. - Hudson, MA 01749
Tel: 978-562-4680 - Fax: 978-562-4681

CALL 1-800-547-5484 TODAY!

INSTRUCTIONS FOR THE ALL-IN-ONE

VAK-MATIC CONTROLLER

10/14/04 - VM2, 4 & 6FS Instructions.cdr

VAKuum Bag

or

Frame Press

Compressed Air

Line

Vacuum Line

Place your VCA6 connector under the bag
wherever it is most convenient for you.

Congratulations, you have just purchased the finest system ever made for VAKuum Bag Veneering & VAKuum
Klamping. This system combines the best features of both applications into one complete system.

To run the system properly, you must make a few modifications when moving from one application to the other.

ON / OFF Valve at rear of box

Keep the valve handle perpendicular to the vacuum line when using the system for veneering (VAK-BAG).
When used for VAK Klaming, turn the valve handle 90 degrees to open the valve. This will allow air to bleed
back to your vacuum jig when you step on the bottom of the foot pedal to turn the air off.

ON/OFF SWITCH

Make sure that when you are clamping you have the red ON/OFF switch on “VAK-KLAMP.” Never have the
switch on “VAK-BAG” when you are clamping.
Only use “VAK-BAG” when you are veneering.

KEEP THE AIR PRESSURE BELOW 100PSI OR YOU WILL DAMAGE THE SOLENOID.

Set up For

Veneering

Set up For

Klamping

D

Advertising