Q.V.P. PINCH KLAMP SET-UP FOR RIGHT ANGLE KLAMPS User Manual
Quality vakuum products, inc, Pinch klamp set-up for right angle klamps, Two klamp setup one klamp setup
Quality VAKuum Products, Inc.
Or visit our site at
www.qualityvak.com
CALL 1-800-547-5484 TODAY!
PINCH KLAMP SET-UP FOR RIGHT
ANGLE KLAMPS
5/4/98 - Pinch Klamp.cdr
To VAK Pump
Two Klamp Setup
One Klamp Setup
Plastic Tee
Pinch Klamp
To VAK Pump
For the third and fourth Klamps,
add Tee’s or a Cross as needed.
Only use the soft tubing on the
Pinch Klamp. You will find 1’ length
supplied with each Klamp.
When working with multiple
Klamps, cover one of the vacuum
holes with tape, then punch a small
whole in the tape. The VAK Pump
will overcome the leakage caused
by the small hole and allow setting
one side of several klamps at once.
The VAK Tape can be applied to
the inside or outside of the right
angle Klamps.
Vacuum
Vacuum
VAK-Tape
On both faces
Vacuum hole
Vacuum
VAK-Tape
On both faces of jig.
Vacuum
Vacuum
VAK-Tape
On both faces
Pinch Klamp
Pinch Klamp
Plastic Tee
Plastic Tee
Plastic Tee
AP
74 Apsley St. - Hudson, MA 01749
Tel: 978-562-4680 - Fax: 978-562-4681