Q.V.P. ES10 Veneering & Clamping at the same time - Manual

ES10 INDUSTRIAL SET-UP DIAGRAM
SIMULTANEOUS VENEERING & KLAMPING
The Electric Pump is always running when doing
VAKuum Klamping; therefore, put the switch on the
Electric Controller to “VAK Klamp.” NEVER do VAKuum
Klamping with the switch on “VAK Bag.”
When you are not using the pump for Klamping keep the
foot pedal off or remove the Klamping set-up and attach
the hose directly onto the filter.
Pressing on its top side creates vacuum to the
VAK Klamp(s) and the VAK Bag(s). Pressing the pedal
on its bottom side shuts off the vacuum from the pedal to
the klamp and allows air to bleed back to the klamp and
release the piece. The check valve prevents air from
bleeding back into the bag.
the pedal
VAKuum
Bag
Filter
Tee
VAKuum
Jig
Electric Pump
Tee
3/25/98 - ES10 Industrial K&V.CDR
Quality VAKuum Products, Inc.
Or visit our site at
www.qualityvak.com CALL 1-800-547-5484 TODAY!
Klamping Set-Up
1/2 I.D.
3/8 I.D.
1/2 I.D.
Pneumatic
Pedal
Electric
Controller
Y
Remove orange plastic plug and screw in filter assembly.
Brass Check Valve
74 Apsley St. - Hudson, MA 01749
Tel: 978-562-4680 - Fax: 978-562-4681