Q.V.P. Glue Spreader User Manual

Quality vakuum products, inc, Instructions for glue spreader

Advertising
background image

Quality VAKuum Products, Inc.

Or visit our site at

www.qualityvak.com

74 Apsley St. - Hudson, MA 01749
Tel: 978-562-4680 - Fax: 978-562-4681

CALL 1-800-547-5484 TODAY!

INSTRUCTIONS FOR GLUE

SPREADER

4/25/2010 r1 - GLUE SPREADER Instructions.cdr

THANK YOU for using our glue spreaders!

Please consider the following maintenance tips.

FOR WOOD GLUES, WITH STORAGE CONTAINER

Partially fill the storage container with water and hang the
spreader with the roller inside and close the lid tightly. Make sure
the roller is in contact with the water. Also, cover the glue hopper
with plastic wrap or wax paper to keep it from crusting over Do
not leave the roller under water for more then one day. As the
roller may begin to swell.

FOR WOOD GLUES, NO STORAGE CONTAINER:

After use, clean the unit with cold or lukewarm water, NOT HOT.
Citrus cleaners help cut the glue. If you don’t have time to do this,
put the complete unit in a bucket of water.

FOR CONTACT ADHESIVES, WITH STORAGE CONTAINER:
GS7 only, NOT the GS5

With our storage container, simply put a small amount of solvent
in the container, hang the spreader unit inside, put some drops of
solvent on the surface of the adhesive in hopper, and close the lid
tightly.

Make sure the roller is NOT in contact with the solvent. The
adhesive will stay fresh and daily clean up is eliminated.

Make sure the storage container is sealed from outside air.

FOR CONTACT ADHESIVE, WITH NO STORAGE
CONTAINER:

After use, clean the unit with solvent. The roller must be removed
and cleaned with a cloth and solvent.

***PLEASE NOTE: the 5 1/2“ ABS Spreader CANNOT be used
with contact adhesives.

AL

Parts Price List 4/12/2011

7” 5.5”

Rubber roller $40

$30

DR Roller

40

25

Lower roller 25

20

Side Pin

15 15

Trigger 35

Stand 30

Prices subject to change w/o notice

Advertising