Q.V.P. NU-Matic 2, 4, & 6 - Manual

Quality VAKuum Products, Inc.
Or visit our site at
www.qualityvak.com
74 Apsley St. - Hudson, MA 01749
Tel: 978-562-4680 - Fax: 978-562-4681
CALL 1-800-547-5484 TODAY!
INSTRUCTIONS FOR THE NU-MAtic
Nu - 2,4, or 6
8/18/06 - Nu-Matic Standard.cdr
Place your VCA6 connector under the bag
wherever it is most convenient for you.
1. Attach your air line to the right side fitting (1/4 NPT).
2. Attach one end of the vacuum line to the barb on the left side of the unit. Block the other end with your
thumb and flip the toggle switch to VAK Bag. The unit should go up to 25“Hg and shut off.
The black knob on the front center of the box is an air regulator, adjust it when the unit is running. The air
pressure gauge must be between 85 and 100 psi when the unit is running. If not, the unit will not get to
vacuum level and shut off.
The VAKuum sensor is just below the toggle switch. Turning it counter clockwise will cause the unit to shut
off at a lower vacuum level. Do not adjust this unless you want less pressure (weak form) or you do not have
enough air to get to vacuum level.
Two very important items to note about the NU-Matic. The air pressure must be kept between 85 and 100
psi. Having the pressure exceed 100 psi could cause damage to some components.
The second item is to provide clean air. If you have filtered air and are using quick disconnects, make sure
that the female connector is clean. Having filtered air will not do you any good if you pick up the female
connector off the floor and it has sawdust and chips in it. These will blow into the components and possibly
cause a problem.
The NU-Matic has a three position toggle switch in the top center of the box. This allows you to turn the unit
on to run continuously or to be regulated when used with a VAKuum Bag or frame Press.
VAKuum Bag
or
Frame Press
Compressed Air
Air Regulator
Toggle Switch
VAKuum Sensor
VAKuum Line