Castle TSM-21 Diagnostic Manual - Manual (Page 45)

Castle Inc TSM-21 Diagnostic Manual v2 Page 45 of 63
5.21 Pilot Hole Alignment 21.72
The Pilot Hole should be drilled in the center of the deepest part of the pocket.
5.21.1 ADJUSTMENT STEPS:
1. From the rear door, locate the hex nut immediately below the Drill T-Knob on the upper
left side of the Motor Carriage. See Fig 24.
2.
Tightening the hex nut moves the drill tip left relative to the operator. Adjust accordingly.
Misaligned Pilot hole
Hex Nut
Drill T-Knob
Fig 24
5.22 Foot Switch (NO) 21.80
The Foot Switch is located in the Foot Pedal. At rest, the Foot Switch is normally OPEN. It works
in conjunction with the Safety Buttons/ Safety Switch. Closing the Foot Switch (while
simultaneously closing the Safety Switch) starts the machine cycle.