Burkert Type 1067 - Manual (Page 62)

E-10-
POSITIONER 1067
Fig. 9 Position of lever during assembly
3 INSTALLATION
Set positioner, with the mounting elbow " 1" screwed on to it, on the membrane drive so that the pin
" 2" slots into the carrier "3", the point of the lever runs parallel with the upper edge of the positioner
(Fig. 9) and the rear side of the positioner runs parallel with the carrier " 3". Fasten the positioner to the
membrane drive in this position as appropriate to the following variants:
- In the case of membrane drives with pillar lanterns, fasten mounting elbow "
1" with two U-bolts "5",
nuts " 13" and washers "12" to the appropriate pillar lantern (Fig. 10a).
- In the case of membrane drives with cast lanterns, fasten mounting elbow " 1" with one screw "13"
(Fig. 10b) or four screws " 13" (Fig. 10c) to the appropriate cast lantern (Fig. 10a).
Fig. 10 Assembly of positioner to a continuous valve with membrane drive
Parallel