2 mounting, 3 connection panel (bottom of instrument), Installation 3.5.2 mounting – Hach-Lange ORBISPHERE Model 51x User Manual User Manual
Page 33
31
Installation
3.5.2 Mounting
Install the instrument on a laboratory table. Place it on a clean flat surface in a safe area. Locate
the instrument convenient to the power source connectors, supplies and the PC.
When carrying the table instrument, grip the top handle firmly, and gently place it on the working
table. Avoid putting the instrument on the floor. The portable instrument provides two folded legs
hidden in the lower frame. Pull them out to modify the display angle to adapt to user positioning
(as illustrated in
).
3.5.3 Connection panel (bottom of instrument)
Figure 12 Table version
1.
Sensor channel 1 - Lemo 10 connector
2.
Sensor channel 2 - Lemo 10 connector
(option)
3.
Sensor channel 3 - Lemo 10 connector
(option)
4.
Ethernet - Harting RJ Industrial
waterproof connector (see
connector (table version) on page 33
). An
adapter cable is available as an option.
5.
Power connection for the external power
supply unit
6.
On/Off power switch
7.
USB-A host connector for mass storage
device
8.
External pressure sensor (option). Lemo
4 connector
9.
USB-B client 4 pin connector. Use the
adapter cable (see
).
10.
Input/Output cable gland (option)