Hach-Lange ORBISPHERE Model 51x User Manual - Manual (Page 36)

34
Installation
PROFInet® color code
3.6.3 USB-B client adapter cable
3.7 Connection to mains power supply
3.7.1 Power supply unit (portable instrument)
For portable instruments, an external power supply unit is supplied as standard. Connect the
power supply unit to the table instrument with the FIXCON® connector provided. Plug the unit
into the mains socket.
Note: Power supply unit input requirements: 100-240 VAC @ 50/60Hz - 1A
3.7.2 Power supply connection (low voltage instruments)
For low voltage instruments (10-30 VDC), connection to the mains power supply is with a 7-pin
BINDER connector (supplied).
Connect the power cable to the connector as follows:
Signal Function Wire color
RJ 45
pin N°
TD+ Transmission Data + Yellow 1
TD - Transmission Data - Orange 2
RD+ Receiver Data + White 3
RD - Receiver Data - Blue 6
Figure 13 USB-B adapter cable
This supplied cable is needed to connect the
instrument to a PC.
Connect to the instrument, and connect the
USB connector to the USB outlet on the
user’s PC.
Figure 14 Wall mount BINDER connector Pin Connections:
2) Power 10-30 VDC
5) Ground
7) Earth
1+ 3 + 4 + 6) Unused