2 starting up, Layout of the lumistox 300 – Hach-Lange LUMISTOX 300 LPV321 User Manual User Manual
Page 5
LUMIStox 300 Operating Manual
Dr. Bruno Lange GmbH
______________________________________________________________________________
______________________________________________________________________________
Page: 5
1.2 Starting up
If necessary, connect the LUMIStox 300 to a printer through the 35-pin parallel (par)
interface, or with a computer through the 9-pin serial (ser) interface. Connect all the
devices to the mains power supply. Make sure that the LUMIStox 300 system diskette
is in the diskette drive.
Switch on the peripheral devices first, then the LUMIStox 300. In the same way as a
PC, the LUMIStox 300 starts up by displaying a series of messages on the screen.
Eventually <Temp: XY.Z
°
C Bitte warten> appears.
Layout of the LUMIStox 300
1 Mains power connection
6 25-pin parallel interface (par)
2 Main switch with cutout
7 3.5" diskette drive
3 Liquid crystal display
8 Nameplate
4 Numeric keyboard
9 Cuvette shaft
5 9-pin serial interface (ser)
F1-F4 Function keys
DR LANG E
LUMIStox
1
2
3
4
5
6
7
8
9
.
0
C
F1 F2 F3 F4
3
4
2
1
5
6
7
8
9