Hach-Lange BUEHLER 3010 4010 4210 4410 Manual - Manual (Page 47)

Operation
Page 47 Manual BÜHLER BU4010ff
- QT-AUTOMATIC (Selection is only available for Flow program)
(Set of MIN. QT-TIME and/or MAX. QT-TIME)
- COMBINED EVENT SAMP.
(Combination of time- resp. Flow program with event; can be activated or
deactivated)
- PROGRAM SEQUENCE
(End of Prg1 can start Prog2....End of Prg.2 can start Prg x, last Prg.
starts Prg. 1 again or xx = endless run)
Program Start
After selection of the menu point “Start Program”, the
program to be started (1-12) has to be selected with the
left or right arrow key and has to be confirmed by
pressing the Enter key.
There are three resp. four possibilities to start the
program.
• IMMEDIATELY
The program is started immediately.
• DATE/TIME
The program start is effected on the selected date and at the
selected time. Format:dd:mm:yyyy hh:mm.
• WEEKDAY/TIME
The program start is effected on the selected weekday and at
the selected time. Format: day; hh:mm