Ransburg DynaFlow Programmers Manual - Manual (Page 36)

Command T
ype
(hex)
Response Or
Action From
User Interface
Response Or
Action From Interface Module
Bit 1 = Job Select BCD 002 Bit 2 = Job Select BCD 004 Bit 3 = Job Select BCD 008 Bit 4 = Job Select BCD 010 Bit 5 = Job Select BCD 020 Bit 6 = Job Select BCD 040 Bit 7 = Job Select BCD 080 Bit 8 = Job Select BCD 100 Bit 9 = Job Select Strobe Bit 10 = System Enable/Fault Bit 1
1 = Global Gun Enable
System Output word: Bit 0 = System Fault Bit 1 = System Pulse Bit 2 = System Spare
<05>
Request Flow T
otals for Job:
<05><LL><0C><JJ> Where: 1) <LL> = message length = <02h) 2) <0C> = Channel # 3) <JJ> = Job #
Response: <05><LL><OC><JJ><DF><DF><DF><DF><YF><YF><YF><YF> <CA><CA><CA><CA><GF><GF><GF><GF><DF><DF><DF><DF> <YF><YF><YF><YF><CA><CA><CA><CA><GT><GT><GT><GT> <CF><CF><CF><CF><AE><AE><AE><AE> Where: 1) <LL> = message length = <2Ah>. 2) <OC> = Channel #. 3) <JJ> = Job #. 4) <DF><DF><DF><DF> = Daily
Total for Job.
5) <YF><YF><YF><YF> =
YTD
Total for Job.
6) <CA><CA><CA><CA> = Calibration
Total for Job.
7)
<GF><GF><GF><GF>
=
Grand
T
otal
for
Job
(YTD
+
Calibration).
8) <DF><DF><DF><DF> = Daily
Total for
All Jobs.
9) <YF><YF><YF><YF> =
YTD
Total for
All Jobs.
10) <CA><CA><CA><CA> = Calibration
Total for
All Jobs.
1
1)
<GT><GT><GT><GT>
=
Grand
T
otal
for
All
Jobs
(YTD
+
Calibration).
12) <CF><CF><CF><CF> = Clean
Total for
All Jobs.
13) <AE><AE><AE><AE> = Summation of the
Absolute V
alue of the Error
Term.
<06>
Request Operational Data for Gun: <06><LL><0G>
Response: <06><LL><0G><FM><FM><FS><FS><GS><GS><TR><TR><RR><RR> <AS><AS><V1><V2><JQ><AJ>
32
DynaFlow Programer's Manual - Introduction
Ransburg
LN-9406-00.3