Ransburg DynaFlow Programmers Manual - Manual (Page 58)

This manual was published to replace Service
Manual LN-9406-00.2, DynaFlow Programmer’s
Manual, to make the following changes:
1. New "Front Cover" depicting touch panel PC.
"Introduction Section"
2. Correct "Description for Word Offset 3 for
Gun configuration RIO BTW - Type 02".
3. Noted "Tolerance Volume Time is Not Used
for Gun configuration SIO command type
0x03".
4. Noted "Tolerance volume time is Not Used
for Gun configuration SIO command type 0x03".
5. Corrected "description of Gun Input &
Forced Gun Input Word bit 4 to be Enable for
Gun configuration SIO command type 0x03".
6. Corrected "description of Gun Input &
Forced Gun Input Word bit 11 to be External
Gun Fault for Gun Configuration SIO command
type 0x03".
7. Added "missing bytes denoted as 56><78>
for System Configuration command".
8. Added "Error Code numbers and descrip-
tions for Error Log command type 0x07".
9. Noted "response to a Start Calibration
command type 0x08 is only an ACK".
10. Noted "response to a Reset Daily Totals for
a Channel for All Jobs command type 0x0A is
only an ACK".
11. Noted "response to a Reset Year-To-Date
Totals for a Channel for All Jobs command type
0x0B is only an ACK".
12. Noted "response to a Reset Calibration
Totals for a Channel for All Jobs command type
0x0C is only an ACK".
MANUAL CHANGE SUMMARY
13. Noted "response to a Reset Clean Totals
for a Channel for All Jobs Command type 0x0D
is only an ACK".
14. Noted "response to a Reset Daily Totals for
Channel for a Job command type 0x0E is only
an ACK".
15. Noted "response to a Reset Year-To-Date
Totals for a Channel for a Job command type
0x0F is only an ACK".
16. Noted "response to a Reset Calibration
Totals for a Channel for a Job command type
0x10 is only an ACK".
17. Noted "response to a Copy All Job
Parameters from Gun/Job to a Range of Gun
W/Job X to Gun Y/Job Z command type 0x11 is
only an ACK".
18. Noted "response to a copy a Single Job
Parameter from Gun/Job to a Range of Gun W/
Job X to Gun Y/Job Z command type 0x12 is
only an ACK".
19. Noted "response to a Copy Attached
Pulses/Liter To a Range of Jobs command type
0x14 is only an ACK".
20. Noted "response to a Send Current Gun
Key command type 0x15 is only an ACK".
21. Noted "response to a Send Forced Analog
Output command type 0x16 is only an ACK.
22. Noted "response to a Reset Grand Total
Volume for a Channel for a Job command type
0x18 is only an ACK".
23. Corrected "description of response packet
for RIO BTW/BTR Buffer request command
type 0x1E.
54
DynaFlow Programer's Manual - Manual Change Summary
Ransburg
LN-9406-00.3