Ransburg DynaFlow Programmers Manual - Manual (Page 40)

Command T
ype (hex)
Response Or
Action From User Interface
Response Or
Action From Interface Module
<0A>
Request to Reset Daily T
otals for a Channel for
All Jobs: <1A><LL><0C> Where: 1) <LL> = message length = <01h>. 2) <0C> = Channel #.
Response: ACK <FF>
<0B>
Request to Reset
YTD T
otals for a Channel for
All Jobs:
<0B><LL><0C> Where: 1) <LL> = message length = <01h> 2) <0C> = Channel #.
Response: ACK <FF>
<0C>
Request to Reset Calibration T
otals for a Channel for
All
Jobs: <0C><LL><0C> Where: 1) <LL> = message length = <01h>. 2) <0C> = Channel #.
Response: ACK <FF>
<0D>
Request to Reset Clean T
otals for a Channel for
All Jobs:
<0D><LL><0C> Where: 1) <LL> = message length = <01h>, 2) <0C> = Channel #.
Response: ACK <FF>
<0E>
Request to Reset Daily T
otals for a Channel for a Job:
<0E><LL><0C><JJ> Where: 1) <LL> = message length = <02h>. 2) <0C> = Channel #. 3) <JJ> = Job #.
Response: ACK <FF>
<0F>
Request to Reset
YTD totals for a Channel for a Job:
<0F><LL><0C><JJ> Where: 1) <LL> = message length = <02h>. 2) <OC> = Channel # 3) <JJ> = Job #.
Response: ACK <FF>
36
DynaFlow Programer's Manual - Introduction
Ransburg
LN-9406-00.3