Ransburg Vector R Series Cascade 79523 R90 Waterborne - Manual (Page 49)

Vector R Series Cascade Applicators - Maintenance
Ransburg
45
Figure 33: Hook and Plug Assembly Removal
5. Remove the hook and hook gasket. Loosen
the plug assembly setscrew and pull the plug
assembly straight out of the applicator.
HANDLE / PLUG
ASSEMBLY
Removal
1. The following procedures must be performed
prior to removing the handle:
• Barrel removal
• Low Voltage Cable removal
• Fluid/Air Hose removal
2. Remove the gasket from the handle; if it was
not removed with the barrel.
3. Remove the fan air adjustment valve, pull the
rear cover straight off.
Figure 31: Air Valve and Rear Cover Removal
4. Remove the air valve retaining cap and o-ring.
Remove the air valve return spring. From the front
of the applicator, push the air valve out the rear
of the applicator. Remove the air valve retaining
nut and seal from the base of the applicator.
Figure 32: Air Valve Removal
1 - Barrel Gasket
2 - Fan Air Adjustment Valve
3 - Rear Cover
1 - Air Valve Retaining Nut
2 - Seal (opening toward applicator rear)
3 - Air Valve
4 - Air Valve Return Spring
5 - Solvent Proof O-Ring
6 - Air Valve Retaining Cap
1 - Hook
2 - Hook Gasket
3 - Plug Assembly Set Screw (loosen)
4 - Plug Assembly (pull straight out)
1
2
3
1
2
3
4
6
5
1
2
3
4
AH-06-01.13