Ransburg, Vector aa90 applicators - operation – Ransburg Vector AA90 79581 Classic User Manual

Page 30

Advertising
background image

Ransburg

26

AH-07-01.9

Vector AA90 Applicators - Operation

The AA90 applicator incorporates a new feature,

that being a locating air cap. Refer to Figure 18

for a view showing the locating pin. This feature

gives the capability to spray with a fan pattern in

either horizontal or vertical positions.

Figure 18: Air Cap Alignment Pin

Figure 19: Pre-Orifice Seal Sizes Dash

Identification

The first two digits of the nozzle dash number indicate the

spray pattern width in inches at a distance of 10- inches

(254mm) from the target. The second two digits indicate

the orifice size in thousandths of inches.
For example: 79691-1015 has a 10-inches (254mm) spray

pattern width and an orifice size of 0.015-inches (.38mm).

Nozzle

Identification

79691-0509

79691-0511

79691-0513

79691-0811

79691-0813
79691-1009

79691-1011

79691-1013
79691-1015
79691-1018
79691-1021

79691-1311

79691-1313
79691-1315
79691-1318

79691-1511

79691-1513
79691-1515
79691-1518
79691-1521
79691-1715

5-in (127)

8-in. (203)

10-in. (254)

13-in. (330)

15-in. (381)

AA90 Fluid

Nozzle

Part #

Pattern

Width at

10-in. (mm)

Nozzle

Orifice Size

in Inches

(mm)

.009 (.23)

.011 (.28)

.013 (.33)

.011 (.28)

.013 (.33)
.009 (.23)

.011 (.28)

.013 (.33)
.015 (.38)
.018 (.46)
.021 (.53)

.011 (.28)

.013 (.33)
.015 (.38)
.018 (.46)

.011 (.28)

.013 (.33)
.015 (.38)
.018 (.46)
.021 (.53)
.015 (.38)

Operating

Parameters

TABLE I

NOZZLE SELECTION GUIDE

79692-01
79692-02
79692-03
79692-04
79692-06
79692-07

.1010" (.256mm)
.1021" (.307mm)
.0141" (.358mm)
.0161" (.409mm)
.0201" (.511mm)
.0221" (.561mm)

Part #

Restrictor Orifice Size

Matching Spray Tip Part #

79691-0509, -1009
79691-0511, -0811, -1011, -1311, -1511
79691-0513, -0813, -1013, -1313, -1513
79691-1015, -1315, -1515, -1715
79691-1018, -1318, -1518
79691-1021, -1521

TABLE II - 79692-XX PRE-ORIFICE SEAL SIZES

Table II shows the available pre-orifice sizes. The

pre-orifice selected should be sized approximately

.025mm (.001-inch) larger than the tip size open-

ing. The pre-orifice can significantly increase the

usefull spray life of the tip.

17-in. (432)

Advertising
This manual is related to the following products: