Ransburg Vector AA90 79581 Classic - Manual (Page 33)

Vector AA90 Applicators - Operation
Ransburg
29 AH-07-01.9
Description Applicator Type
6
START-UP DISPLAY
85 kV Classic
Figure 35: Power Supply Start-Up Display
START-UP
(CLASSIC UNITS)
After all installation procedures are completed,
operation of the applicator may begin. When the
ON-OFF switch is turned on, the kV display will
show the applicator type the 9060 Power Supply
is configured for and the microamp display will
show the current software revision level. These
items are displayed for about 2-3 seconds.
SETTING AND
ADJUSTING OUTPUT
VOLTAGE
The voltage on the 80130-41X power supply is
adjustable between 20 kV and full kV DC. The
factory preset voltages are Preset 1 - full kV minus
20 kV, Preset 2 - full kV minus 10 kV, and Preset
3 - full kV.
The Vector applicator system has three voltage
setpoints 1, 2, and 3. Each of these setpoints
can be individually adjusted between 20 and full
kV using the + and - buttons on the front panel
of the power supply. When the + or - buttons are
held in longer than 1 second, the kV display will
begin incrementing or decrementing in units of 5
instead of 1.
When the applicator trigger is off, the present
setpoint can be changed by pressing the 1, 2, or
3 buttons on the front panel.
Figure 36: kV Adjust/Setpoint Buttons
BASIC OPERATIONS
(CLASSIC UNITS)
Triggering
High voltage is actuated by pulling the trigger
to start the flow of atomizing and fan control air
through the applicator. When the applicator is
triggered, an air flow switch is activated, the kV
setpoint is displayed on the kV display, the ac-
tual current draw on the µA display and the high
voltage light illuminates. Under the µA display
is a bar graph meter that illuminates according to
the actual current draw.
Figure 37: µA Bar Graph Meter Display