IAI America ERC - Manual (Page 42)

22

Rod Type
A bolt is attached on the rod end bracket, so use this bolt to affix the load. (Use the supplied nut, if necessary.)
Rod end bracket
Model Rod end bracket
RA54 M8, length 18 mm
RA64 M10, length 21 mm
Note) Apply a spanner at the rod end bracket to prevent
the rod from receiving any rotating moment when
the load is installed.
Applying excessive rotating moment to the rod may
damage the rod.
RA54: Width across flats 13 mm
RA64: Width across flats 17 mm

Rod type with a guide(s)
Model Nominal thread size
RA54GS M5
RA54GD
M5
RA64GS M6
RA64GD M6
Tightening torque Nominal
thread size Bolt bearing surface: steel Bolt bearing surface: aluminum
M5 7.3 Nm (0.74 kgfm) 3.4 Nm (0.35 kgfm)
M6 12.3 Nm (1.26 kgfm) 5.4 Nm (0.55 kgfm)
Single guide
Double guides
Tapped holes are provided in the guide bracket. Affix the work
using these holes (shown by the arrows in the figures at left).