IAI America ERC - Manual (Page 53)

33
3.5 Configuration Using a SIO Converter
If any of the following conditions applies, use a SIO converter to connect the teaching pendant, PC or PLC’s
communication module:
[1] The actuator’s rear cover cannot be reached and therefore the teaching pendant or PC cannot be connected.
[2] Want to execute movement operation or parameter edit for all axes when multiple axes are connected to the
single equipment.
[3] Want to operate the actuator via serial communication using the PLC’s communication module.
Note: Do not connect a teaching pendant and a PC at the same time. If both are connected at the
same time, a communication error (message level) will occur.
PERSONAL
COMPUTER
PC software
<RCB-101-MW>
Optional
Teaching pendant <RCA-T>
Optional
Cable length: 5 m
Host system <PLC>
Relay cable
Standard cable
<CB-ERC-PWBIO * * *>
Robot cable
<CB-ERC-PWBIO * * *-RB>
Cable length: 1 m, 3 m, 5 m
 PIO
SIO 
SIO converter
<RCB-TU-SIO-A>
<RCB-TU-SIO-B>
ERC actuator
24-VDC control/motor power supply (2 A or more)
Brake release switch
Emergency-stop/motor-power cutoff circuit
Drain wire
TB2 TB1
EMG
2
EMG
1
24V 0V
FG
B A
RS232C crossed
cable (provided
by the user)