IAI America RCA2-SA6R - Manual (Page 51)

43
8. Installation and Storage/Preservation
8. Installation and Storage/Preservation
8.1 Installation Environment
• Location exposed to radiant heat from a huge heat source such as the heat treatment
• Location where the surrounding air temperature exceeds the range of 0 to 40
oC
• Location where condensation occurs due to abrupt temperature changes
• Location where relative humidity exceeds 85%RH
• Location exposed to direct sunlight
• Location exposed to corrosive gases or combustible gases
• Location exposed to significant amount of dust, salt or iron powder (Outside of ordinary assembly plant)
• Location where water, oil (includes oil mist and cutting fluid) or chemical is splashed
• Location where the product main body receives vibration or hit impact
Open space required for maintenance inspection
8.2 Storage/preservation Environment
The storage and preservation environment should comply with the same standards as those for the
installation environment. In particular, when the machine is to be stored for a long time, pay close
attention to environmental conditions so that no dew condensation forms.
Unless specially specified, moisture absorbency protection is not included in the package when the
machine is delivered. In the case that the machine is to be stored and preserved in an environment
where dew condensation is anticipated, take the condensation preventive measures from outside
of the entire package, or directly after opening the package.
For storage and preservation temperature, the machine withstands temperatures up to 60
oC for a
short time, but in the case of the storage and preservation period of 1 month or more, control the
temperature to 50
oC or less.
Storage and preservation should be performed in the horizontal condition. In the case it is stored in the
packaged condition, follow the posture instruction if any displayed on the package.
250mm
250mm
300mm
When using the product in any of the locations specified below, provide a sufficient shield.
• Location subject to electrostatic noise
• Location where exposed to the influence of strong electric or magnetic field
• Location where exposed to the influence of ultraviolet or radiant rays
Do not use this product in the following environment
It is generally the environment where a worker can work without any protection gear.
Also make sure to keep enough work space necessary for maintenance.