IAI America RCA2-SA6R - Manual (Page 71)

63
13. Maintenance Inspection
13.5 Internal Inspections
Turn off the power and inspect visually after turning up or removing the stainless sheet in the case of
stainless sheet types. With reversing types, inspect visually after removing the reversing bracket.
When inspecting the interior, check the following items.
Main unit Loose mounting bolts, other loose items
Guide section Lubrication, buildup
Belt
(Reversing type)
Belt wear, damage
Visually inspect the interior of the equipment. Check whether dust or other foreign matter has gotten inside
and check the lubrication state.
The lubrication may have turned brown. This is not a problem as long as the travel surfaces shine as
though they are wet.
If the grease is mixed with dust and does not have a shiny appearance, or if the grease has lost its
efficacy due to prolonged use, then clean each section and reapply grease.
The procedure for internal inspections is outlined below. Refer to 13.8 for inspection and adjustment of the
belt.
"Slider type" --- Steps [2] through [5] are only necessary if the cover is attached. If you do not have a cover,
only do step [1].
[1] Move the slider to the home position side.
[2] Remove the cover.
[3] Remove the sheet retainer screws.
[4] Peek under the stainless sheet and check the interior.
[5] When the checks are completed, reassemble the parts by following the same procedure in reverse.
Cautions for attached cover:
When checking inside the equipment, be careful not to forcibly bend the stainless sheet or scratch it.
Do not tug on the stainless sheet or in any way attempt to reposition it.
If the sheet is repositioned, it may not be even which may shorten its service life. Should this happen,
adjust the stainless sheet by referring to the replacement instructions.
Keep in mind that the edges of the stainless sheet can cause injuries. Always wear gloves when working
on it.