IAI America RCA2-SA6R User Manual
Page 77
69
13. Maintenance Inspection
Cellophane tape
Stainless sheet
Stainless sheet
[3]
Apply cellophane tape to one side of the new stainless sheet.
Apply the cellophane tape as though sandwiching the stainless sheet, leaving about 3 mm of tape sticking
out from the stainless sheet. Cut off the excess tape.
[4]
Slide the stainless sheet, taped end first, in through the gap under the slider cover.
[5]
Fasten the two stainless sheet retainer plates with the four screws. Use a 1.5 mm hex wrench.
[6]
After fastening the stainless sheet retainer plate, move the slider by hand a full stroke and ensure
that the stainless sheet neither floats up nor is warped. If there is a problem, go back to step [5].
Do not let stainless sheet fall in this hole.
Two grooves are cut into the main unit to
serve as guides for attaching the
stainless sheet. Install the stainless sheet
so that it comes to the center of the two
grooves. Be careful not to install it in a
position where it bends.
Caution: When moving the slider back and forth by hand, be certain never to apply force in excess
of the thrust direction external force capacity (see 11.1.2). (If the slider will not move,
operate it using a jog function.)